Estimated Installation Time: 120 minutes Tools required: -Flat head and Philips head screw drivers (large and small) -Needle nose pliers -Ratchet and extension -13mm socket and 7 mm socket (or 7mm nut driver) -6mm or ¼” Punch -Hammer -Dremel tool with a multi-purpose cutting bit (strongly recommended) -Eye protection – safety glasses -Work table -Bench vise -White lithium based grease -Shop towels or rags…

This manual is available for download….. 1. Locate the center plastic panel under the handbrake. Pull up on it to free the clips holding it in place and put it in a safe area for re-installation later. 2. Pull up on the rear plastic panel behind the one you just removed. Put it in a safe place for re-installation later. 3. Remove the stock shift knob by rotating the black ring at the top of the boot about ¼ to ½ turn while pulling down. Lift up on the shift knob to remove from the shaft. This requires some effort as it is a friction fit and there are small white tabs at the bottom of the shift knob that rest in a groove. A small screwdriver may be used to assist in releasing the shift knob while puling it up. Pull up to free the tabs and remove the shift knob….

Download TWM Performance Short Shifter Installation Manual 2005 and up Chevrolet Cobalt/ Pontiac Pursuit.Pdf