87-91 Ford Bronco Installation Instructions 1 Read instructions completely and carefully before you begin. Checkthekitfor proper contents (refer to parts list and picture diagrams). 2. Park the vehicle on a clean, dry flat (level) surface. Block the tires so the vehicle cannot roll in either direction. Automatic transmissions should be placed in neutral. 3. Remove both battery cables. Be sure to disconnect the negative cable first, then the positive cable. 4. Remove the screws that mount the doorjamb scuff plates to the body. Remove the scuff plates. Gently remove the plastic tab that mounts the front kick panels. Be very careful not to break the plastic tab. Gently pull out on the kick panels until they come loose. Remove the two screws that mount each rear kick panel. Remove both rear kick panels. Pull the carpeting back to expose the four rubber access hole covers. 5. Remove the screws mounting the rear scuff plate to the body at the rear tailgate area. Remove the scuff plate. Remove the screws mounting each side panel to the body. Pull the side panels out enough to allow the carpeting to be pulled up. Pull the carpeting up enough to expose the rubber access hole cover just behind the rear seat. Remove the access hole cover. 6. Remove the air intake duct where it mounts on top of the radiator. Gently pull up on the plastic tabs being especially careful not to break them. Pull the air duct up and out of the way….

Download 87-91 Ford Bronco Installation Instructions.Pdf