Installation Manual Hard-Armâ„¢ Suspension: Triangulated 4-Link Package Deal 1999 – 2004 Jeep Grand Cherokee Last Revision No.: 10/1/08 www.claytonoffroad.com 12 Damage or Missing Parts …. Last Revision No.: 10/1/08 Thank you for purchasing a Clayton Off Road Mfg Long arm suspension. Installation Manual Hard-Armâ„¢ Suspension: Triangulated 4-Link Package Deal 1999 – 2004 Jeep Grand Cherokee Last Revision No.: 10/1/08 www.claytonoffroad.com 1 Thank you for purchasing a Clayton Off Road Mfg Long arm suspension. Please check to make …

Installation Manual Hard-Armâ„¢ Suspension: Triangulated 4-Link Package Deal 1999 – 2004 Jeep Grand Cherokee Last Revision No.: 10/1/08 www.claytonoffroad.com 4 7. Bolt new cross member together. Transmission mount holes are offset to one side. Please use your OEM cross member as a reference point. The mounting plates do NOT have to line up. The 45 degree angled plates are opposite to properly position the transmission. 8. Center the new cross member and secure it using the two mounting holes on each side. 9. Install four transmission mount bolts. 10. Make four welds on each side where the cross member contacts the uni body frame rail and old cross member mount. One on the end, one down each side and cross the inside. Make sure these are good welds! Welding technique is to run two passes. First one is done using short welds of 3/8″ to 1/2″ at a time. This insures that you don’t burn through the uni-body. If the weld gets too hot stop and wait for it to cool then start again. Once you have this first bead laid in run a second pass over it. You will be able to make this a continuous bead weaving the bead a little to get a nice penetrated bead. Again if you see the welds getting too hot stop and wait…..

Download 1999 – 2004 Jeep Grand Cherokee Installation Manual Hard-Arm Suspension: Triangulated 4-Link.Pdf